Resources for Rolling Doors

      DATA SHEETS / SPECIFICATIONS

PDFS

AUTOCAD .DWG

Data Sheet 1: End Elevation
Typical door in bulkhead detail.

Data Sheet 2: Rear Elevation
Typical door opening viewed from inside.

Data Sheet 2A: End Elevation
2 doors in a single opening with a removable mullion.
Mullion can be positioned off centre if required.

Data Sheet 2B: Typical Elevation
Of single roller shutter door with removable side guides.

Data Sheet 2C: Rear Elevation
Typical door opening viewed from inside.

Data Sheet 3: Typical Bulkhead Detail
Two doors in a single opening with removable centre mullion.

Data Sheet 3B: Typical Bulkhead Detail
Single door opening. Spring balanced manual operation.

Data Sheet 3C: Typical Bulkhead Detail
Two doors with a removable centre mullion. Two different counter heights.

Data Sheet 4: Plan View
Showing two doors in a single opening with a removable standard mullion. Mullion can be positioned off centre if required.

Data Sheet 4A: Plan View
Single door in typical opening manual spring balanced.

Data Sheet 4B: Internal Corner
Plan view - showing two doors with a removable corner mullion.

Data Sheet 4C: Internal Angle
Plan view - showing two doors mounted on angled bulkhead.

Data Sheet 4D: External Angle
Plan view - showing two doors with a removable angle mullion.

Data Sheet 4E: Plan View
Showing two doors with special wide removable mullion.

Data Sheet 4F: Plan View
Doors mounted at same height level, to internal angled bulkhead.

Data Sheet 4G: Plan View
Internal angled bulkhead.

Data Sheet 4H: Three Doors
Three doors side by side in a common opening.

Data Sheet 4I: Plan View
Three doors mounted to external angled bulkhead face.

Data Sheet 4J: External Corner
Plan view - showing two doors mounted to bulkhead face.

Data Sheet 4K: Plan View
Doors at same height level - Adjacent door reverse rolled.

Data Sheet 5: HC1
Elevations showing heavy duty motorising clearances.

Data Sheet 6: SD1
Elevations showing standard motorising clearances - single phase only.

      FRAMING DETAILS

PDFS

AUTOCAD .DWG

Data Sheet 7
Important considerations for planning and installation.

Data Sheet 7A
Typical Framing Detail - Single spring balanced manual operated door up to 3000mm high guides 'face' fixed.

Data Sheet 7B
Typical Framing Detail - Two manual doors with removable mullion.

Data Sheet 7C
Typical Jamb Details - Showing minimum framing requirements with door guides recessed.

      INSTRUCTIONS & OTHER DOCUMENTS

PDFS

AUTOCAD .DWG

Fixing Instructions & Warranty Guide

Roller Door Installation Instructions

Care and Maintenance of your Roller Door

Removable Mullion Instructions

SD1 Motor Set Up Instructions